Changzhou Huayuan drying equipment Co. Ltd
Chairman:Yin Xiaojun
Mob：013706113822
General manager: Mr Liu
Mob:+86-13506122053
Tel:+86-519-88679278
+86-519-88679111
Fax:+86-519-88679298
Sale：+86-519-88672111
Add：Industry emplder section
jiaoxi three hekou changzhou city,jiangsu china
Email:czhugc@chinahuayuan.com
Website:www.mctiot.net
Sludge dryer is a kind of the wedge-shaped hollow blade and cylinder device wall heat conduction principle, indirect heating for the printing and dyeing wastewater sludge and the type of paste or paste the sludge, the sewage sludge or sewage sludge and sludge produced to dewatering, reduce the volume, then the comprehensive utilization of waste. Two, to avoid secondary pollution, is currently the dyeing sludge treatment was the most ideal drying equipment.
The sludge drying machine adopts special wedge type stirring heat transfer paddle, which has high heat transfer efficiency and self cleaning function of heat transfer surface. The structure is arranged on the hollow shaft of the hollow shaft, and the heat transfer area of the unit effective volume is large, and the heat medium can be used as a carrier such as steam, heat conduction oil, and the like, and the temperature is at 18-230. Because the life of sludge water treatment sludge or dyeing wastewater belongs to paste or paste, sludge dryer design, using the wedge blade heat transfer surface, the relative movement of continuous paste or paste mud and produce a wedge blade surface erosion, so both sludge granular, powder, paste, paste, wedge heat transfer equipment the surface has self-cleaning function better.
In addition to the drive shaft of the wedge shaped hollow blade, the outer shell adopts a circular bottom, the upper part is a rectangle, and the shell is arranged with a 2-4 root hollow stirring shaft, and a sealing end cover is arranged between the shaft and the casing. The upper cover body can prevent the material from leaking, and the wet steam can be collected simultaneously. In order to ensure the drying effect, the material bit baffle is arranged at the discharging port to ensure the material height, so that the heat transfer surface is covered by the material and the heat conduction effect is fully played. The heat transfer medium (steam or heat transfer oil) of the dryer is connected to the shaft through the shaft end of the rotary joint, and the casing is sheathed with the hollow shaft to heat the material simultaneously.
